Intermec EasyCoder 201 II Technical Manual page 26

Intermec EasyCoder 201 II – Technical Manual
SETUP PARAMETERS, cont'd.
Media Size, cont'd.
6 dots/mm (153.9 dpi):
1 dot = 0.165 mm = 6.5 mils
8 dots/mm (203.2 dpi):
1 dot = 0.125 mm = 4.9 mils
Length serves three purposes:
• To decide the length of the printable area from origin and along
the Y-coordinate as a number of dots.
• To decide the amount of paper feed when using "fix length
strip".
• To set an "emergency stop", which only works when the
printer is setup for "Label (w gaps)", "Ticket (w mark)", or
"Ticket (w gaps)". If the label stop sensor has not detected a
gap or mark within 150% of the set length, the paper feed is
automatically stopped to avoid feeding out a whole roll of
paper, e.g. because of a blocked or faulty label stop sensor.
This implies that you can use label or tickets longer than the
printable area as illustrated by the following table:
Density:
Max. printable area (9999 dots):
Max. label or ticket length:
By setting up the X-start, the Width and the Length, you will
create a "print window" in which the printing can be performed, as
illustrated on the next two pages. Any object or field protruding
outside the print window in any direction will cause an error
condition (Error 1003 "Field out of label") and the printing will be
inhibited.
6 dots/mm 8 dots/mm
1,650 mm (65.0") 1,250 mm (49.2")
2,475 mm (97.4") 1,875 mm (73.8")
Continued!
25