Intermec EasyCoder 201 II Technical Manual page 24

Intermec EasyCoder 201 II – Technical Manual
SETUP PARAMETERS, cont'd.
Detection, cont'd.
6 dots/mm (153.9 dpi):
1 dot = 0.165 mm = 6.5 mils
8 dots/mm (203.2 dpi):
1 dot = 0.125 mm = 4.9 mils
Rec. adjustments:
Density: 6 dots/mm 8 dots/mm
Peel Off:
Start adjust: -17
Stop adjust: 0
Tear Off:
Start adjust: -39
Stop adjust: -23
Strip:
Start adjust: -39
Stop adjust: 0
Cut between labels:
Start adjust: -233
Stop adjust: +233
Cut var. length strip:
Start adjust: -233
Stop adjust: +210
For more information on the instructions
FORMFEED and PRINTFEED, see
Intermec Fingerprint Reference Manual
or Intermec Direct Protocol Programmer's
Guide.
Feed Adjustment
The feed adjustment contains two parameters, Start adjustment
and Stop adjustment, that will be effected regardless of which
program is run. Such global adjustments can be further modified for
various purposes by the use of
Fingerprint Reference Manual) within the currently running pro-
gram.
Note: It is possible to turn off the label stop sensor or black mark
sensor for a certain amount of paper feed, and to override the start
adjustment and stop adjustment setup by means of the Intermec
Fingerprint statement
Reference Manual. This feature is especially useful when a black
mark on the back of the paper is combined with preprinted
information that may interfere with the detection of the black mark.
-22
0
The Start Adjustment is given as a positive or negative number of
dots:
-52
-30
• A positive start adjustment means that the specified length of
paper web will be fed out before the printing starts. According-
-52
ly, the origin is moved away from the forward edge of the copy.
0
(This has the same effect as a positive
before a
PRINTFEED
-310
• A negative start adjustment means that the specified length of
+310
paper web will be pulled back before the printing starts. Accord-
ingly, the origin is moved towards the forward edge of the copy.
-310
+280
(This has the same effect as a negative
before a
PRINTFEED
The Stop Adjustment is set up the same way.
• A positive stop adjustment means that the specified length of
paper web will be fed out after the printing is completed.
Accordingly, the origin is moved away from the forward edge of
next copy. (This has the same effect as a positive
statement after a
• A negative stop adjustment means that the specified length of
paper web will be pulled back after the printing is completed.
Accordingly, the origin is moved towards the forward edge of
next copy. (This has the same effect as a negative
statement after a
FORMFEED
, see the Intermec Fingerprint
LBLCOND
statement).
statement).
statement).
PRINTFEED
statement).
PRINTFEED
statements (see Intermec
statement
FORMFEED
statement
FORMFEED
FORMFEED
FORMFEED
23