Interleaved 2 Of 5 Enhancements; Keypad Control - Intermec Trakker Antares 2460 Supplementary Manual

Trakker Antares 246X Stationary Terminal User's Manual Addendum

Interleaved 2 of 5 Enhancements

Description:
Syntax:
Default:
Scan:

Keypad Control

Description:
Syntax:
Default:
Scan:
14
Interleaved 2 of 5 (I 2 of 5) is a high-density, self-checking, continuous numeric
symbology. With firmware version 6.15 and later, you can now set two additional
parameters.
CAdata
Additional values for data are:
95 Case code (6 or 14) with check digit verified but discarded
96 Variable length with check digit verified but discarded
Existing values for data are 0, 2-32, 97, 98, and 99. Only the new values for data are
described in this section. For more information about the existing values, see
"Interleaved 2 of 5" in Chapter 8, "Configuration Command Reference," in your user's
manual.
Disabled
One of these bar codes:
Enable Case Code With Check Digit
Verified But Discarded
*$+CA95*
*$+CA95*
Enables or disables the keypad. When you disable the keypad, you cannot use the
keypad to enter information into the terminal.
KEdata
Acceptable values for data are:
0 Disable keypad
1 Enable keypad
Enabled
One of these bar codes:
Disable Keypad
*$+KE0*
*$+KE0*
Enable Variable Length With Check Digit
Verified But Discarded
*$+CA96*
*$+CA96*
Enable Keypad
*$+KE1*
*$+KE1*