Configuration Command Updates; Beep Duration - Intermec Trakker Antares 2460 Supplementary Manual

Configuration Command Updates

This section describes the following new and updated configuration commands:
•
•
•
•
•
•
•

Beep Duration

Description: Sets the length of the terminal's audio signals. You can define a different duration for
the high and the low beep tone. Use the beep duration with the beep volume to define
beeps according to operator preference and work environment.
Syntax: BDdatabeep
Acceptable values for data are any number from 2 to 7999 ms.
Acceptable values for beep are:
H
L
Default: 50 ms, high and low beep tones
Scan: To set the default beep duration, scan this bar code:
Default Beep Duration
*$+BD50HBD50L*
*$+BD50HBD50L*
Or: To set a beep duration:
1. Scan this bar code:
C39
nugget
Beep Duration
DHCP (Terminal)
Interleaved 2 of 5 Enhancements
Keypad Control
RS-232 or RS-422/485 COM2 Interface Update
Symbology Identifiers
UPC/EAN Update
High
Low
Enter Accumulate Mode / Set Beep Duration
*+/$+BD*
*+/$+BD*
Configuration Command Updates
11