Dhcp (Terminal) - Intermec Trakker Antares 2460 Supplementary Manual

Trakker Antares 246X Stationary Terminal User's Manual Addendum
Beep Duration (continued)

DHCP (Terminal)

Description:
12
2. Scan a numeric value for data from these bar codes:
*0*
*0*
*2*
*2*
*4*
*4*
*6*
*6*
*8*
*8*
3. Scan the beep tone for which you are setting the beep duration:
High
*H*
*H*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
When DHCP (Dynamic Host Configuration Protocol) is enabled on the terminal, the
terminal can receive terminal IP addresses dynamically from the DHCP server. With
firmware version 6.20 and later, you can use DHCP on a TCP/IP network to allocate
permanent terminal IP address assignments.
The DHCP configuration command described in these instructions differs from the
DHCP command available in previous firmware versions. The previous DHCP
command that supports UDP Plus networks and allocates controller IP addresses is still
available.
*1*
*1*
*3*
*3*
*5*
*5*
*7*
*7*
*9*
*9*
Low
*L*
*L*