Intermec Trakker Antares 2415 Programmer's Manual page 73

Native Terminal Emulation Programmer's Guide
3) Concatenate (6400, 5055)
Each bar code read is added to the end of the previous bar code read until
the 6400 or 5055 Terminal meets a condition forcing transmission to the
host.
When this option is OFF, each bar code read is placed at the beginning of
the current input field. After a bar code is placed in a field, any subsequent
read replaces the first read.
4) BC Type Char (6400, 59XX, 17XX, 11XX)
This option adds a character associated with the bar code type at the be-
ginning of the scanned bar code. See page 260 for bar code type characters.
5) Stream Scan
If the scanned bar code is too big for the input field, the overflow informa-
tion appears in the next field and continues until the entire bar code is en-
tered. When this option is OFF, and the scanned bar code is too big for
the input field, the overflow information is dropped.
6) Scan All Flds
When this option is selected, the scanner is enabled when the cursor is in
an input field. When this option is OFF, the host computer must enable
the scanner for each input field that requires scanned data.
7) More
This brings you additional scanning options that adjust scanning timeout
and characters sent before and after the scanned data.
S 1) Scan Timeout (59XX, 17XX, 11XX)
Use this option to adjust the scanning timeout period from 1 to 200
seconds. When using a proximity-detect scanner, you can shorten the
timeout period to speed up scanning while also reducing the duration of
errant scans. With a long-range scanner, you may want to increase the
timeout period to ensure sufficient aiming time.
Scan Timeout
Seconds
XXX
S 2) Scan PreChar and 3) Scan PostChar
Enter a hexadecimal value from 00–FF for the character to be sent pre-
ceding the scanned data or after the scanned data. The value of 20h
means that pre- or post-characters are not sent.
Scan Options
1) Scan Timeout
2) Scan PreChar
3) Scan PostChar
—
Chapter 3 Using the Terminal Emulation Menus
1) Scan Timeout is for 59XX, 17XX, 11XX
53