Configuring Usb Communications; Configuring Ethernet Communications - Intermec 741 User Manual

Configuring USB Communications

Configuring Ethernet Communications

741 and 751 Mobile Computers (Windows Mobile 5.0) User's Manual
You can place your computer in a single dock, multidock, modem dock, or
vehicle dock to transfer data to and receive data from another device using
USB communications. The USB cable and all of the docks are sold
separately. For information on accessories and how to order them, see
"Accessories" on page 93.
To use USB communications with your computer
1 Connect the dock to the USB port of the other device using an
appropriate USB cable.
2 Make sure your USB device is configured for USB communications.
3 Insert the computer into the dock and turn it on.
A status box appears on the screen to show that the computer is making a
USB connection.
You can use your computer directly in an Ethernet network if you use the
Ethernet Adapter Cup or one of the communications docks. The adapter
cup provides an RJ-45 connector off of it to connect to your Ethernet
network and the communications docks provide an Ethernet connector
that allows your computer to communicate in an Ethernet network.
To use your computer in an Ethernet network
1 Tap the iConnect icon (
screen. The iConnect pop-up menu appears:
2 Select Enable > Ethernet.
3 (Optional) Configure the IP Settings for the Ethernet Adapter if you are
not using DHCP. DHCP is the default setting.
4 (Optional) If required for your network, you may also need to set these
parameters on each computer:
• Primary and secondary DNS servers
• Primary and secondary WINS servers
5 Make sure that your computer is talking to the network and that the
network can see your computer.
Chapter 3 — Configuring the Computer
) in the lower right corner of the Today
45