Removing The Battery - Intermec 741 User Manual

Chapter 1 — Using the Computer

Removing the Battery

4
3 Tilt, insert, and place the battery into the compartment. Make sure the
battery compartment latch clicks in place to ensure the battery is secure.
Battery compartment latch
Battery compartment
4 Insert your 741 or 751 into its single dock for charging.
5 Charge the battery pack for three hours before using.
You must use only the Intermec power supply approved for use with the
computer. Using any other power supply will damage the computer.
Note: For help installing and using the single dock, see the 700 Series Single
Dock Quick Start Guide (P/N 962-040-009) shipped with the dock.
Follow these instructions to remove the battery from the computer.
Only use the battery compartment latch to dislodge and remove the
battery. Using any other tool or method to remove the battery may
damage the battery or the 741 or 751.
Removing the main battery when the backup battery low icon appears
on the status bar may cause your computer to cold boot and you may
lose data.
If you fail to replace the battery immediately, you may lose important
data or applications.
To remove the battery
1 Press the On/Off (I/O) key to suspend the computer.
741 and 751 Mobile Computers (Windows Mobile 5.0) User's Manual
Battery pack