Insert the piston back into the housing of outlet pipe assembly by turning it and
screw the locknut back in position.
13.5 PRODUCTION BASIN DISINFECTION
Desinfection process:
make sure that the mixture treating control panel is in STOP state;
make sure that the ejection opening is well closed;
open the basin cover;
fill the basin with a disinfecting mixture;
fill the basin with water (doubble click DESIRED TEMPERATURE key);
close the cylinder cover and let the disinfecting mixture rest for 20
minutes.
While doing so, please pay special attention to instructions of the
disinfection agent manufacturer as well as hygienic standards, which are
valid in your country!
14 MAINTENANCE OF THE APPLIANCE
14.1 INSTRUCTIONS FOR PREVENTION OF INJURIES
Authorized servicing personnel may only perform removal of the top cover and
side panels and any intervening actions inside the machine.
Removal of the top cover and side panels and any intervening actions inside the
machine is strictly forbidden when the machine is connected to the power
supply.
It is strictly forbidden to connect the machine to the power supply if top cover
and side panels are not properly attached and all required security measures
are not in place.
Cleaning or lubrication of parts, which are moving or rotating, is forbidden.
14.2 PROBLEMS, ERRORS AND TROUBLESHOOTING
Malfunctions and errors are caused mostly by incorrect use, improper or
inadequate maintenance or incorrect connection of the appliance.
Therefore the operators must always carefully follow the instructions.
68