Walking; Running Short Distances ("Walk-To-Run" Function); Sitting Down; Sitting - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

9.1.2 Walking

Initial attempts at walking with the prosthesis always require the instruction of trained, quali­
fied personnel.
The hydraulics stabilise the knee joint in the stance phase and release the knee joint in the
swing phase so that the leg can swing forward freely.
Switching to the swing phase requires that the prosthesis roll over to the front out of the
stride position.

9.1.3 Running short distances ("walk-to-run" function)

For covering short distances quickly, the knee joint detects a transition from walking to run­
ning in basic mode and automatically changes the following settings:
•
•
The requirements to automatically switch to the running motion are fast forward movement of
the prosthetic leg and high dynamic load on the knee joint. When stopping from the running
motion, the changed settings are set back to the standard values.
INFORMATION
For covering longer distances, a "Running" MyMode can be configured using the adjustment software (see
page 96).

9.1.4 Sitting down

The resistance in the prosthetic knee joint while sitting down ensures even bending into the
sitting position.
The adjustment software can be used to configure whether the sitting process is to be sup­
ported or not.
1) Place both feet side by side at the same level.
2) While sitting down, weight should be distributed evenly between both legs and the arm
3) Move the buttocks in the direction of the back support and lean the upper body forward.
INFORMATION: Resistance while sitting down can be changed with the Cockpit app
via the parameter "Resistance" (see page 92).

9.1.5 Sitting

INFORMATION
While sitting, the knee joint also switches to energy saving mode. This energy saving mode is activated regardless
of whether the sitting function is activated or not.
If the patient is in a sitting position for more than two seconds (i.e. the thigh is close to hori­
zontal and there is no load on the leg), the knee joint switches the resistance to a minimum
in the extension direction.
A sitting function can be enabled using the adjustment software. For more information about
the sitting function, see the following section.

9.1.5.1 Sitting function

INFORMATION
To use this function, it needs to be enabled in the adjustment software. It also has to be activated using the Cock­
pit app (see page 92).
Genium X3 3B5-3/3B5-3=ST
The swing phase angle is increased
Preflexion of 4° at heel strike (PreFlex) is reduced to 0°
supports used where applicable.
Use
89