Control Display And Fault Descriptions - LEAB 600W Series User Manual

2.5

Control display and fault descriptions

The control lamp (three-colour LED) on the front of the device indicates the different operating and fault
statuses:
The different statuses are indicated by permanent or flashing light. See section 2.2 on the position of the
LED.
LED display on the battery charger
LED Status
Permanent light
orange
Permanent light
green
Permanent light
red
Flashing
red
Table 1: LED display on the CPC battery charger
* Pre-charging is not necessary for programs with start voltage 0 V
LED display on the optional remote display
If you have the optional LED remote display installed (see section 4.5), the CPC statuses will also be
displayed there in the same way as described above.
All manuals and user guides at all-guides.com
LEAB Automotive -CPC
Description
Battery is being charged, the CPC is in
the main charging phase
Battery fully charged, the CPC is in the
maintenance charging phase
No battery connected or connected
battery exhaustively discharged
Time exceeded in the main charging
phase, charging interrupted
LEAB Automotive GmbH
Measure
none
The battery charger can be unplugged and the
battery used
Check the battery connection, measure the battery
voltage, pre-charge the battery using the power
supply*
Battery faulty: Check battery
Battery too large for the battery charger: choose
larger battery charger
Parallel consumers too large: Switch consumers off
during charging
Page - 11 -