LEAB 600W Series User Manual page 22

All manuals and user guides at all-guides.com
LEAB Automotive -CPC
General notes
The charging output is short-circuit-proof: no hazardous state occurs for the device
even when the charging cable is connected directly.
The charging output is protected against inverse polarity: the battery or the CPC will
not be damaged if you mix up the battery connections; charging is not possible with
inverse battery connections.
Sparks can fly if the charging cable is connected to a battery with the battery charger
switched on.
Make sure there is a good electrical contact, clean the battery terminals before
connection if necessary.
All-round rubber edges protect any sensitive surfaces the device is set down on. Keep
the rubber feet in particular clean of dirt and solvents so that this protection effect is
not jeopardised.
Always connect the charging cables to the battery terminals first before you connect
the device to the mains in order to avoid sparking.
Always select the charging program to match the type and size of battery on the CPC;
the wrong selection can lead to the battery not being charged correctly or becoming
damaged due to excess charge.
Protect the battery charger from water and humidity.
Check the battery charger regularly for damage and replace any faulty or worn
connection cables immediately.
Do not open the device, there are no components the user can operate inside the
device.
Clean the device feet regularly and do not expose them to acids, oil and aggressive
cleaning agents.
When charging refillable lead-acid batteries open the cover so that any gases
produced can escape.
Clean the air inlets and outlets regularly if heavily soiled.
LEAB Automotive GmbH
Page - 22 -