Otto Bock C-Leg Protector 4X860 Series Instructions For Use Manual page 13

• Taleo Harmony: 1C52
• Taleo Low Profile: 1C53
• Triton side flex: 1C68
• 1D35 Dynamic Motion
• 1M10 Adjust
Protector foot cuff according to foot size
INFORMATION
The product "1B1=*/1B1-2=* Meridium" includes a connection plate that must be used for con­
necting the Protective Cover.
The connection plate is compatible with cuff sizes S and M. Cuff size M is equivalent to foot size
29 for the Meridium.
INFORMATION
The foot cuff is not compatible with the slim footshells.
3 Intended use
3.1 Indications for use
The product is to be used solely for lower limb exoprosthetic fittings.
3.2 Area of application
The product was developed for everyday use and must not be used for unusual activities such as
extreme sports (free climbing, paragliding, etc.).
In principal, the product can be used with a rotation axis-floor-measurement* of 430 mm -
560 mm.
An exception is fittings with the 1C61 Triton Vertical Shock prosthetic foot. Due to the height of
the foot, the fitting area is restricted to 470 mm - 560 mm.
*Position of the alignment reference point of the C-Leg (rotation axis): 20 mm above the medial
tibial plateau.
Rotation axis-floor-measurement measured while standing (barefoot)
INFORMATION
For smaller users that require the Protector to be substantially shortened, the foot cuff material
can extend forwards into the area of the shield insert. The rotation axis-floor-measurement at
which this may occur depends on the foot cuff size being used.
3.3 Contraindications
• All conditions which contradict or go beyond the specifications listed in the section on
"Safety" and "Indications for use".
3.4 Qualification
The fitting of patients with the product may only be carried out by qualified personnel (such as an
O&P professional).
Foot size
Up to 25
26 to 28
From 29
• 1E56 Axtion
• 1E57 Lo Rider
• 1B1 Meridium
• Meridium: 1B1-2
• Empower: 1A1-1
Cuff size
S
M
L
13