Installation - LEAB CHAMP PRO 24 V User Manual

8 Installation

8 Installation
The charger is designed for permanent installation in vehicles. When installing
the charger, note the following:
To install the charger in the vehicle, proceed as follows:
1. Disconnect the battery from the vehicle power circuit.
WARNING! Disconnect the negative cable first.
2. Connect the plug of the DC cable to the connection cable that is connected
to the battery. NOTE! Use the appropriate connection cable for the con-
nection.
ð The device is installed.
Connection to 230 V mains
To install the device to the 230 V mains, proceed as follows:
NOTE! The charger is only suitable for connection to fused, earthed 230 V
mains supplies.
1. Connect the mains plug to a 230 V mains supply.
ð One of the 4 charging LED flashes orange while the device is connecting
to the battery. There is no voltage output at this stage.
ð After 2 seconds, the LEDs of the charge status indicator flash, the char-
ging process starts.
ð The charging progress is indicated in the charge status indicator via the
illuminated LEDs.
ð If the green LED on the charge status indicator is lit, the charge is com-
plete and the battery can be disconnected from charger.
ð The charger is connected to the 230-V mains supply.
16 LEAB Automotive GmbH
Notice
Incorrect installation can damage the device
The negative lead of the unit may contain a temperature sensor.
1. Never shorten or extend the negative cable with a temperat-
ure sensor.
LEAB Automotive GmbH
Thorshammer 6 24866 Busdorf