Operation; Charging The Battery; Change Charging Characteristic - LEAB CHAMP PRO 24 V User Manual

LEAB Automotive GmbH

9 Operation

9.1 Charging the battery

To start the charging operation, proceed as follows:
ü The device is installed.
ü The battery is connected.
1. Connect the mains plug to a 230 V mains supply.
ð Charging starts automatically, the yellow LED of the charge status indic-
ator lights up.
ð If the charging current is 15% below the maximum value, the yellow and
green LEDs of the charging status indicator light up.
ð When the battery is fully charged, the green LED on the charging status
indicator lights up and indicates the trickle charge
ð The battery is charged.
9.2 Charging the battery
To start the charging operation, proceed as follows:
ü The device is installed.
ü The battery is connected.
1. Connect the mains plug to a 115 V mains supply.
ð Charging starts automatically, the yellow LED of the charge status indic-
ator lights up.
ð If the charging current is 15% below the maximum value, the yellow and
green LEDs of the charging status indicator light up.
ð When the battery is fully charged, the green LED on the charging status
indicator lights up and indicates the trickle charge.
ð The battery is charged.

9.3 Change charging characteristic

To change the charging characteristic, proceed as follows:
ü The device is installed.
ü The battery is connected.
LEAB Automotive GmbH Thorshammer 6
9 Operation
24866 Busdorf 17