Advertisement
Available languages
Available languages
3.2 Conditions of use
The product is intended exclusively for use with the approved components (Combination possib
ilities).
The product may only be used in a controlled environment indoors (orthopaedic workshop, gait
laboratory) under the supervision of trained, qualified personnel. The patient must not be left unat
tended while wearing the product.
3.3 Contraindications
•
All conditions which contradict or go beyond the specifications listed in the section on
"Safety" and "Indications for use".
3.4 Qualification
The fitting of a patient with the product may only be carried out by an O&P professional.
4 Safety
4.1 Explanation of warning symbols
Warning regarding possible risks of accident or injury.
CAUTION
Warning regarding possible technical damage.
NOTICE
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc
tions. Consequences are presented as follows if more than one consequence is possible:
>
E.g.: Consequence 1 in case of failure to observe the hazard
>
E.g.: Consequence 2 in case of failure to observe the hazard
This symbol identifies activities/actions that must be observed/carried out in order to avert
►
the hazard.
4.3 General safety instructions
CAUTION
Non-observance of safety instructions
Personal injury/damage to the product due to using the product in certain situations.
Observe the safety instructions and the stated precautions in this accompanying document.
►
CAUTION
Long-term storage of the product with the batteries installed
Skin irritation due to contact with leaking battery fluid or damage to the product.
If the product will not be used for extended periods of time, remove the batteries from the
►
battery compartment.
Use suitable protective gloves to remove leaking batteries.
►
CAUTION
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth
devices, WiFi devices)
Falling due to unexpected behaviour of the product caused by interference with internal data
communication.
13
Advertisement
