Driver Installations; I Microsoft Windows Xp (Service Pack 2) - Icom ID-RP2 Instruction Manual

5

DRIVER INSTALLATIONS

IMPORTANT!
A different USB driver from the ID-1 is used for the
ID-RP2 system.
Uninstall the USB driver for ID-1 first, then install the
USB driver for ID-RP2 system if the USB driver for
ID-1 is installed in the PC.
I Microsoft
® Windows ® XP
(Service Pack 2)
Select
Click
19
The USB
(Universal Serial Bus)
is used for the connection between ID-RP2
separately)
and a PC.
So, the USB driver installation is required for the PC.
In addition, individual USB driver installation is required
for each connector and unit, because the communica-
tion port number difference.
In this instruction, describes with the installation of the
ID-RP2C [SERVICE1] connector for example.
NOTE:
The repeater unit connection may not be recognized
with the PC according to the using USB cable length.
Use the shorter USB cable as possible is recom-
mended.
q Start up the Windows.
• Quit all applications if activated.
w Insert the CD that comes with the ID-RP2C, into the
CD drive.
e Connect the PC and ID-RP2C [SERVICE1] con-
nector using with an USB cable
.
separately)
r "Found New Hardware ID-RP2C SERVICE 1" ap-
pears as at left.
t The "Found New Hardware Wizard" will come up as
at left.
Select "No, not this time" then click [Next>].
cable
(A-B type; purchase
(A-B type; purchase