I Usb Driver Un-Installation - Icom ID-RP2 Instruction Manual

5
DRIVER INSTALLATION

I USB driver un-installation

IMPORTANT!
As described at first of this section, USB driver is in-
stalled for each unit and connector.
However, only one USB driver can be un-installed
when using "Add and Delete" included in OS. So,
you should perform the USB driver un-installation
with the following instructions.
Double-click
Fro Windows XP/2000
Fro Windows 98/ME
Click
Un-install the USB drivers as follows.
q Start up Windows.
w Insert the CD that supplied with the ID-RP2C into
the CD drive.
e Open the CD drive directory using "My Computer"
or "Explorer."
• Contents of the CD are displayed.
r Double click the "Driver" and then the "Uninstall"
folders to open and display the Uninstall folder con-
tents.
t Run the appropriate batch file according to the OS.
• For Windows XP/2000
• For Windows 98/Me
y The DOS screen appears and the un-installer starts
automatically.
• The un-installer starts several times according to the
• Make sure no equipment is connected to the USB port,
• The screen as at left below appears after the un-instal-
Click
33
number of installed USB drivers.
then click [Continue].
lation, click [Finish].
NOTE: NEVER close the DOS screen manually.
The un-installation is interrupted and the drivers
cannot be un-installed properly when the DOS
screen is closed manually.
• For Windows XP/2000:
The DOS screen will be closed automatically
after clicking [Finish].
• For Windows 98/Me:
Click [Finish] then close the DOS screen manu-
ally.
: "UNRP2_NT.BAT"
: "UNRP2.BAT"