What If The Files On The Tf Card Cannot Be Identified?; What If The Offset Occur On The Finished Model?; Damage Occurs When Turn On The 3D Printer; Too Much Filament Oozing? - Voxelab Aquila User Manual

Trouble shooting
Q：
What if the files on the TF card cannot be identified?
A： 1. Clean and wipe the storage card
2. Format the storage card
3. Replace the storage card
Q： What if the files are garbled and cannot be read?
A：
1. Modify the file name to the English or numeric format;
2. The format of files after slicing is not compatible;
3. Repair the model before slicing.
Q： What if the noise occur for the return to zero device?
A： 1. Check the return to zero sensor to see whether it has been knocked;
2. Check the lines and see whether the noises could stop if the sensor is pressed
by hand;
3. Take the replacement method to check.
Q：
Unable to resume printing from power failure?
A：
It might be caused by different TF card. Make sure the TF card before and after
the power failure are the same one.
Q： What if the offset occur on the finished model?
A：
1. Check the tightness of the synchronous belt and ensure the correct installation
of the synchronous belt;
2. Slice the model anew
3. Reduce the printing speed or adjust the acceleration value;
4. Ensure that the operating temperature didn't exceed its assigned set-point
temperature 30℃.
Q：

Damage occurs when turn on the 3D printer.

A：
It might be caused by dialing error from switch power supply, please check
whether the voltage is set to the correct value. If the voltage is 110V and the
power supply is 220V, damage will occur. Please select 110V/230V by switch
before power on.
Q：
Too much filament oozing?
A： 1. Reduce the printing temperature by 5~10℃;
2. Increase the traveling speed, or increase the with retraction length and speed.
Q： No filament coming out during printing?
A：
1. The arm force of the feeding structure might be too tight to allow the filament
out. Please adjust the arm force, neither too loose nor too tight.
2. Lower the retraction length to avoid any abrasion.
3. Check whether the extruder is clogged, clean it through the needle if
necessary.
27