Table of Contents
Advertisement
Content
Thank you for choosing and using the products of Voxelab Technology.
For your convenience, please read this manual carefully before use and
follow the manual strictly. The Voxelab team is always ready to provide
you with the perfect service. Please contact us by email listed, if you have
any problems.
Email：support@voxelab3dp.com
You can also get operational knowledge of the equipment from the
following way:
Voxelab website: www.voxelab3dp.com
Users can get the software, firmware, device maintenance and relevant
contact information via Voxelab website.
A
Notes
Product Introduction
Spare Parts
B
How to assemble Aquila
C
Use The 3D Printer
Start Printing
Wire connection
Printing Notice
Trouble Shooting
01
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Aquila and is the answer not in the manual?
Questions and answers
I have a Voxelab Aquila X2. My nozzle is hitting the bed before the limit switch can stop from hitting. How do I rectify the issue?
To fix the nozzle hitting the bed on a Voxelab Aquila X2 before the limit switch stops it, follow these steps:
1. Check the Z-Axis Limit Switch: Ensure the Z-axis limit switch is properly installed and positioned. If it is too low, adjust its position upwards so it triggers before the nozzle touches the bed.
2. Adjust the Bed Leveling Knobs: Turn the leveling knobs counterclockwise to lower the bed slightly, preventing the nozzle from hitting it too soon.
3. Use Auto Home Function: In the printer menu, select *Auto Home* to ensure the extruder moves to its correct home position.
4. Modify Z-Offset: If needed, adjust the Z-offset in the printer settings to fine-tune the nozzle height.
5. Check for Obstructions: Ensure there are no obstructions or loose parts affecting the movement of the Z-axis.
By following these steps, the nozzle should stop at the correct height before touching the bed.
This answer is automatically generated
I'm in search of a new extruder kit for my aquila S3, could you please tell me what I would need in order to replace the factory extruder