Table of Contents
Advertisement
！
Printing notice
1.
The adhesions of the glass build plate may decrease after a long time of use. Please apply proper amount of glue to keep and improve the adhesion.
2.
In the cold environment, abnormalities may easily happen because of warping when printing with ABS filament. Please utilize glue to enhance the
adhesion; if the ambient temperature is too low, it is not recommended to print with ABS filament, which can easily make the model break away from
the build plate and cause printing failure.
3.
There is a certain quivering on the build plate during the printing which may cause the flatness to change. Thus please pay attention to the adhesion
of the first layer when printing the second model; if the distance of build plate and nozzle is not right, please re-level it.
4.
If the accuracy of model is not right, please confirm the normal installation of the synchronous belt and please adjust it to its normal state if it is too
loose or too tight. If there is no error regarding the synchronous belt, please check the transmission ratio in the settings. Turn up the transmission ratio
if the size turns smaller and turns down the transmission ratio if the size turns larger.
5.
If the accuracy of Z-axis height dimension is not good enough, please pay attention to the compensation setting of Z-axis for precision compensa
tion.
6.
If the build plate will shaking, please adjust the tightness of the pulley via a wrench and slowly slide the build plate to see whether all four wheels
under build plate can rotate. The pulley is at the right position when the build plate does not shaking again.
7.
If there are shakes at the XZ components, please adjust the distance between the pulley and the structural section properly via an open-ended
wrench; the wheel can be rotated by hand.
8.
The optimal temperature for printing is 18~30℃. The printing will be affected when the ambient temperature is too high or too low.
25
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Aquila and is the answer not in the manual?
Questions and answers
I have a Voxelab Aquila X2. My nozzle is hitting the bed before the limit switch can stop from hitting. How do I rectify the issue?
To fix the nozzle hitting the bed on a Voxelab Aquila X2 before the limit switch stops it, follow these steps:
1. Check the Z-Axis Limit Switch: Ensure the Z-axis limit switch is properly installed and positioned. If it is too low, adjust its position upwards so it triggers before the nozzle touches the bed.
2. Adjust the Bed Leveling Knobs: Turn the leveling knobs counterclockwise to lower the bed slightly, preventing the nozzle from hitting it too soon.
3. Use Auto Home Function: In the printer menu, select *Auto Home* to ensure the extruder moves to its correct home position.
4. Modify Z-Offset: If needed, adjust the Z-offset in the printer settings to fine-tune the nozzle height.
5. Check for Obstructions: Ensure there are no obstructions or loose parts affecting the movement of the Z-axis.
By following these steps, the nozzle should stop at the correct height before touching the bed.
This answer is automatically generated
I'm in search of a new extruder kit for my aquila S3, could you please tell me what I would need in order to replace the factory extruder
A compatible replacement for the factory extruder on the Voxelab Aquila S3 is an all-metal dual gear extruder, such as a BMG clone.
This answer is automatically generated