Delete Pallet; Figure 16: Delete Pallet Screen; Figure 17: Confirm Delete - Vektek Guardian User Manual

Vektek Guardian™ User's guide
2. Using the
3. Select the pallet from the list using the
4. The MACHINE RECEIVER will prompt PALLET # Stored and return to the main
screen.
To "wake up" a FIXTURE TRANSMITTER:
1. Pass the provided magnet over the Guardian™ logo on the FIXTURE TRANSMITTER.
The FIXTURE TRANSMITTER LEDS should flash momentarily.
2. Check the status of the FIXTURE TRANSMITTER on the MACHINE RECEIVER to
ensure the proper status is displayed.
NOTE: FIXTURE TRANSMITTERS must remain in STORE mode for a minimum of 1 minute
before they can be awakened.
Delete Pallet
The Delete Pallet option removes the pairing between the FIXTURE TRANSMITTER
and the MACHINE RECEIVER so that they no longer communicate.
To Delete a FIXTURE TRANSMITTER:
1. Press ENTER from the main screen

2. Use the
3. Once again using the
ENTER.
4. The MACHINE RECEIVER will ask to confirm as shown below, press ENTER to
confirm or BACK to cancel.
5. Once the FIXTURE TRANSMITTER is deleted, it will need to remain in
communication range with the MACHINE RECEIVER for approximately 30 seconds
to finish the delete process.
P L 3 3 0 2 R e v . P 0 8 I A W N / A
© Copyright 1986‐2010 by Vektek, Inc.
 
and buttons, scroll to Store Pallet and press ENTER
Figure 16: Delete Pallet Screen

and buttons to scroll to Delete Pallet option and Press ENTER.
 
and buttons, select the pallet to be deleted and press
Figure 17: Confirm Delete
 
and buttons, and press ENTER.
P a g e | 19 of 39