System Settings; Editing Ip Settings - Cisco MCS 7800 Series Administration Manual

System Settings

System Settings
System Settings are initially configured during Cisco TelePresence Multipoint Switch (CTMS)
Administration software set up. Use the System Settings to make changes to these initial settings. System
Settings consists of four configuration areas:
•
•
•
•

Editing IP Settings

Figure 4-1
Figure 4-1
To edit IP settings:
Click System Settings under the System Configuration folder in the Navigation Pane.
Step 1
Click the IP Settings tab. IP Settings screen displays a table providing the IP Settings fields. Most of the
Step 2
settings displayed on the IP Settings screen are configured during initial installation of the CTMS
Administration software. Only three fields can be configured on this screen:
•
•
•
Edit settings (as needed) as described in
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
4-22
Editing IP Settings, page 4-22
Editing Access Settings, page 4-23
Configuring and Editing QoS Settings, page 4-24
Configuring and Editing Resource Management, page 4-28
shows the IP Settings screen.
IP Settings
IP Address
Subnet Mask
Default Gateway
Chapter 4
Table 4-1
Configuring CTMS Administration Software
OL-12586-02