Configuring And Editing Cisco Telepresence Manager Settings - Cisco MCS 7800 Series Administration Manual

Chapter 4 Configuring CTMS Administration Software
Table 4-7
Field or Button
Stop Media Port
Transport Layer Protocol
•
•

Configuring and Editing Cisco TelePresence Manager Settings

These setting are used to register CTMS with Cisco TelePresence Manager (CTS-Man) for scheduled
meetings.
Figure 4-10
Figure 4-10
To configure or edit CTS-Manager settings:
Click CTM Settings under the System Configuration folder in the Navigation Pane to open the CTM
Step 1
Settings window.
CTM Settings displays a table providing the Cisco TelePresence Manager Settings configuration fields.
Step 2
Enter or edit settings (as needed) as described in
OL-12586-02
SIP Profile Settings
Setting
Designates the stop real-time protocol (RTP) port for media. Media
port ranges from 16384 to 32766. Default specifies 32766.
Select TCP or UDP for this field. Both transport types are supported.
TCP is the recommended transport type.
Note
To register new or modified settings, click Apply.
To restore the original settings, click Reset.
shows the Cisco TelePresence Manager Settings screen.
Cisco TelePresence Manager Settings
Configuring and Editing Cisco TelePresence Manager Settings
Whenever the transport type is modified in CTMS, the
corresponding transport type for the Unified CM trunk
setting must be changed to match the CTMS transport type.
Table 4-8
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
4-35