Cisco MCS 7800 Series Administration Manual page 59

Chapter 5 Managing Meetings
Table 5-8
Field
Switching Policy
Video Announce
Quality
VIP Mode
Lock
OL-12586-02
Active Meetings Settings
Description
Defines how CTMS calls are displayed during a meeting. CTMS
displays active speakers on screen. There are two active speaker
display options:
• Segment: (Speaker) With segment switching, each individual
table segment (defined as a display and a camera) is displayed
on the screen as that segment becomes the active speaker.
Site: (Room) When you select "site," all table segments for a
•
particular room are displayed on screen when any segment in
that room is the active speaker.
Click the appropriate radio button to select.
If you are running CTS 1.3 or later, you can control how
Note
Cisco TelePresence calls are displayed from the Cisco
TelePresence phone interface. Press the Speaker softkey to
display the active segment; press the Room softkey to
display all segements from a particular site.
When selected, if a new attendee joins the meeting, the attendee is
displayed on-screen for 2 seconds. Options are Yes and No. Click
the appropriate radio button to select.
This field sets the system bandwidth and screen resolution. A higher
bandwidth increases video quality, but may also cause packets to be
dropped and video to be interrupted. Choices:
Highest Detail, Best Motion: 4Mbps 1080p
•
Highest Detail, Better Motion: 3.5Mbps, 1080p
•
Highest Detail, Good Motion: 3Mbps, 1080p
•
High Detail, Best Motion: 3Mbps, 720p
•
High Detail, Better Motion: 2Mbps, 720p
•
• High Detail, Good Motion: 1Mbps, 720p
Default is Highest Detail, Best Motion: 4Mbps 1080p.
When selected, one endpoint is defined as the "VIP." A VIP is
broadcast to all other meeting attendees for the entire meeting. The
VIP's endpoint continues to switch between endpoints with active
speakers. Only one VIP can be defined per meeting.
Options are "Yes" and "No." Click the appropriate radio button to
select.
Locking the meeting means that no settings can be changed for this
meeting. Options are Yes and No. Click the appropriate radio button
to select.
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
Viewing and Editing Active Meetings
5-57