Table of Contents
Advertisement
Measure Voltage
Measure Voltage
Measure Voltage
Measure Voltage
Measure Voltage
You can log voltage measurements that you make using your
multimeter. These will appear when viewing or printing the
results of the Auto Test. When you have finished entering
the measurements, press the
Compensation
Compensation
Compensation
Compensation
Compensation
Compensation is added directly to the signal level measure-
ments. You can use this to compensate for losses associated
with probe points found on certain amplifiers. The default is
the Probe Compensation value specified in Configure. Enter
a different value if necessary. Press the
continue.
Results File Name
Results File Name
Results File Name
Results File Name
Results File Name
Enter the name you want to use for the results file that is
created. Your CLI-1450 will let you know if there is already a
results file with the name that you enter. If desired, you can
overwrite an existing file of the same name. When you are
ready for the next step, press the
Type of Test
Type of Test
Type of Test
Type of Test
Type of Test
Tests can be executed immediately or scheduled over a
period of time. Use the up and down arrows to select the type
of test you want and then press the
Set Schedule
Set Schedule
Set Schedule
Set Schedule
Set Schedule
This screen will appear only if you have selected a scheduled
test. The default schedule will perform four intervals over a
twenty-four hour period beginning at the present time and
date. If you require a different schedule, use the up and down
arrows to edit the schedule and then press the
soft key.
soft key to
soft key.
soft key.
soft key.
2-27
Advertisement
Table of Contents
