Printing The Screen; Storing A Scan File; Auto Test; Configuring An Auto Test - Wavetek Wandel Goltermann CLI-1450 Operation Manual

Scanning signal level & leakage meter

Table of Contents

PRINTING THE SCREEN

You can print the entire screen at any time by pressing the SHIFT +

keys. A bar graph appears indicating the status of the printout.

Press the SHIFT +

a file. A screen will appear asking you to enter a name for the file.

Once stored, you will be able to recall the file at a later time and view

it on the Scan screen. You will be able to adjust the screen settings the

same as when you are viewing a "live" measurement. See the section

on VIEW mode to find out how to access files that you have stored.

Your CLI-1450 is capable of performing unattended, automated level

measurement sequences. The sequences can be programmed to

repeat over a period of time. Measurement data is stored into a file

that can be viewed, printed or uploaded to StealthWare. See the

section on VIEW mode to find out how to access files from Auto Tests

that you have performed.

Important

When performing an Auto Test, only the channels enabled in the

currently selected channel plan are measured.

Choose the

mated test sequence. Your CLI-1450 will guide you step by step.

If desired, you can log information about the location at

which you are performing the test. The information will be

stored in the Auto Test file along with the measurement data.

It will be available when viewing and printing the Auto Test

results. This first screen presents you with a list of available

locations. To create a new location, press the

Press

keys to store the current scan measurement into

icon from the NAVIGATOR to configure an auto-

Choose Location

soft key to delete the location highlighted in the

soft key.

2-25

Table of Contents