Table of Contents
Advertisement
IMPORTANT: You may find an enabled channel that is
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
not in your channel plan. This should be disabled. A channel
may be missed if the frequency is special or level too low.
IMPORTANT
IMPORTANT
IMPORTANT: You must enable a channel to perform measure-
IMPORTANT
IMPORTANT
ments on it.
Channel Plan Parameters/Characteristics to edit
Channel Plan Parameters/Characteristics to edit
Channel Plan Parameters/Characteristics to edit
Channel Plan Parameters/Characteristics to edit
Channel Plan Parameters/Characteristics to edit
The Configure- Edit Channel screen lists the following parameters/
characteristics:
ENABLED
TYPE
FREQ (MHz)
CHANNEL NUMBER
LABEL
CARRIER
CENTER FREQ (MHz)— Digital
MEAS BW (MHz)— Digital
PACKAGE
SCRAMBLED
AUD OFFSET (MHz)
Enabled
Enabled
Enabled
Enabled
Enabled
As mentioned earlier, a channel must be enabled in order to
be measured. This is another place where you can enable or
disable the channel.
1-30
Advertisement
Table of Contents
