Wavetek Wandel Goltermann CLI-1450 Operation Manual page 26

Scanning signal level & leakage meter
Table of Contents

Advertisement

You can selectively enable or disable each individual limit. When a
limit is disabled, your CLI-1450 excludes it when checking limits. If
the highlighted limit is disabled, you can enable it by pressing the
soft key. A check mark appears in the left-hand column to
indicate when a limit is enabled. If the limit is already enabled,
pressing the
Note
Note
Note
Note
Note
Analog limits are enabled by factory preset default. Digital limits are
disabled by factory preset default.
Note
Note
Note
Note
Note
If you disable all of the limits within a test point, the test point
becomes disabled. You cannot enable a test point that has no enabled
limits.
You can edit the value of the highlighted limit by pressing the
key. When the edit box becomes active, enter the desired value. Be
sure to press the
all desired test points are enabled and edited, the unit will be able to
measure digital signals during an Installation Check or an Auto Test.
Press the
soft key to return all limits in the test point to their
factory preset values.
CALIBRATION
CALIBRATION
CALIBRATION
CALIBRATION
CALIBRATION
Performs user calibration for optimum measurement accuracy. Press
the
key to access the calibration options.
soft key disables it.
key when finished to terminate your entry. Once
1-19

Advertisement

Table of Contents
loading

Table of Contents