Measurement Hold - Wavetek Wandel Goltermann CLI-1450 Operation Manual

Note Note
Note Note Note
Be sure that you have enabled all of the test points that you are
interested in using. The
than one enabled test point. (see EDIT TEST POINTS).
When you have selected the limits submenu. the marker information
below the graph is replaced by the overall limit check summary for
currently being displayed on the graph currently being displayed on the graph
channels currently being displayed on the graph currently being displayed on the graph currently being displayed on the graph. For each
limit, the worst case actual value is displayed along with a pass/fail
status. The results are updated upon completion of each scan. When
the cursor is on an analog channel, all the analog limits are displayed.
When the cursor is on a digital channel, the digital limits are displayed
as shown below.
Cursor on Analog Channel
You can quickly check to see if all SCAN carriers are within limits by
looking at the PASS/FAIL indicator above the graph.

MEASUREMENT HOLD

MEASUREMENT HOLD MEASUREMENT HOLD
MEASUREMENT HOLD MEASUREMENT HOLD
You can freeze the scan measurement at any time by pressing the
SHIFT + keys. The measurement is retained even if the cable is
disconnected from the input port. Notice that the mode icon in the
upper left-hand portion of the screen flashes when the measurement is
on hold. Press the SHIFT +
measurement is not retained when another mode is selected or the
CLI-1450 is shut off.
2-24
soft key is only available if there is more
Cursor on Digital Channel
keys again to release the hold. The