Selecting Channel Packages; Selecting The Test Point - Wavetek Wandel Goltermann CLI-1450 Operation Manual

Press the key to select the INSTALLATION mode or choose
the icon from the NAVIGATOR. Your CLI-1450 will begin
measuring all the enabled channels in the plan. A bar graph indicates
the percentage of channels measured. When your CLI-1450 has
finished, you can view the results and verify that all channels are
within limits.

SELECTING CHANNEL PACKAGES

SELECTING CHANNEL PACKAGES SELECTING CHANNEL PACKAGES
SELECTING CHANNEL PACKAGES SELECTING CHANNEL PACKAGES
If you have configured channel packages, a list of available packages
will appear. From this list, you can select the packages that the
subscriber has ordered. The number to the right of the package name
tells you how many channels are included in each package. Use the
up or down arrows to highlight a package and then press the
key to select it. A check mark appears in the left-hand column of the
list indicating that the package is selected. If the highlighted package
is already selected, pressing the
Tip Tip
Tip Tip Tip
Select "ALL CHANNELS" if you want to include all the enabled
channels in the plan.
Press the soft key or
CLI-1450 will only evaluate the channels from the packages that you
have selected.
Tip Tip
Tip Tip Tip
You can return to this screen at any time to change your package
selection by pressing the

SELECTING THE TEST POINT

SELECTING THE TEST POINT
SELECTING THE TEST POINT SELECTING THE TEST POINT SELECTING THE TEST POINT
The next thing you should do is tell your CLI-1450 at which test point
you are located. This determines which set of limits are used. Press
the soft key to sequence through the available test points. The
test point that you have selected is represented in the upper portion of
the screen by one of the following icons:
2-8
soft key deselects it.
when you have finished. Now your
soft key.
soft