Measurement Peak; Adjusting The Alarm Volume; Selecting The Antenna Type - Wavetek Wandel Goltermann CLI-1450 Operation Manual

MEASUREMENT PEAK

MEASUREMENT PEAK
MEASUREMENT PEAK MEASUREMENT PEAK MEASUREMENT PEAK
The peak leakage value is indicated on the analog meter as a solid
line. It also appears numerically as shown below:
The peak value is reset periodically. You can specify how quickly
you want it to reset (see PEAK HOLD RESET PERIOD in the
Leakage Configuration section).
Tip Tip Tip Tip Tip
You can manually reset the peak value at any time by pressing the
SHIFT + keys.

ADJUSTING THE ALARM VOLUME

ADJUSTING THE ALARM VOLUME ADJUSTING THE ALARM VOLUME
ADJUSTING THE ALARM VOLUME ADJUSTING THE ALARM VOLUME
An audible sound is produced when the alarm is triggered. You can
raise or lower the volume of the alarm by pressing the left and right
arrows. There is a bar meter in the lower right-hand portion of the
display to help you set the volume. You can mute the alarm by
pressing the
time. You can adjust the length of this time (see ALARM MUTE
TIME-OUT in the Leakage Configuration section).
Note Note
Note Note Note
You can adjust the threshold and specify the conditions at which the
alarm is triggered when you configure your unit (see the Leakage
Configuration section).

SELECTING THE ANTENNA TYPE

SELECTING THE ANTENNA TYPE SELECTING THE ANTENNA TYPE SELECTING THE ANTENNA TYPE SELECTING THE ANTENNA TYPE
You can use your CLI-1450 with several different types of antennas.
For accurate measurements, you should be sure that you have se-
lected the correct type for the antenna you are currently using. Press
the soft key to sequence through the available antenna types.
The type you have selected is represented in the upper portion of the
screen by one of the following icons:
key. The alarm will remain muted for a period of
Monopole
Dipole (HD-1)
Vehicle Mount (VMA-3)
Custom
2-3