Table of Contents
Advertisement
Up or down arrows to the left of the video level and DVA numeric
measurement tell you when the limits have been exceeded.
When an adjacent channel error occurs, one of the following indicators
will appear in the lower left-hand area of the marker information area:
MEASUREMENT HOLD
MEASUREMENT HOLD
MEASUREMENT HOLD
MEASUREMENT HOLD
MEASUREMENT HOLD
You can freeze the scan measurement at any time by pressing the
SHIFT +
keys. The measurement is retained even if the cable is
disconnected from the input port. Notice that the mode icon in the
upper left-hand portion of the screen flashes when the measurement is
on hold. Press the SHIFT +
measurement is not retained when another mode is selected or the
CLI-1450 is shut off.
PRINTING THE SCREEN
PRINTING THE SCREEN
PRINTING THE SCREEN
PRINTING THE SCREEN
PRINTING THE SCREEN
You can print the entire screen at any time by pressing the SHIFT +
keys. A bar graph appears indicating the status of the printout.
STORING A SCAN FILE
STORING A SCAN FILE
STORING A SCAN FILE
STORING A SCAN FILE
STORING A SCAN FILE
Press the SHIFT +
a file. A screen will appear asking you to enter a name for the file.
Once stored, you will be able to recall the file at a later time and view
it on the Scan screen. You will be able to adjust the screen settings the
same as when you are viewing a "live" measurement. See the section
on VIEW mode to find out how to access files that you have stored.
WARNING INDICATORS
WARNING INDICATORS
WARNING INDICATORS
WARNING INDICATORS
WARNING INDICATORS
If the current measurement is inaccurate due to an out-of-range
condition or a hardware failure, your CLI-1450 warns you by
measurement too high
measurement too low
lower adjacent channel level
upper adjacent channel level
both upper and lower adjacent channel levels
keys again to release the hold. The
keys to store the current scan measurement into
2-19
Advertisement
Table of Contents
