Annunciators - Wavetek Wandel Goltermann CLI-1450 Operation Manual

You can read the leakage measurement numerically and on an analog
meter. The units in which leakage is being measured appears directly
below the meter.
Note Note
Note Note Note
You can select the units you want to measure leakage in when you
configure your CLI-1450 (see LEAKAGE UNITS in the Leakage
Configuration section).
The frequency being monitored appears in the upper right-hand
portion of the screen.
Note Note
Note Note Note
You can specify the frequency of the carrier you want to monitor when
you configure your unit (see MEASUREMENT FREQUENCY in the
Leakage Configuration section).

ANNUNCIATORS

ANNUNCIATORS ANNUNCIATORS
ANNUNCIATORS ANNUNCIATORS
Annunciators appear in the area below the measurement frequency to
alert you of the following conditions:
Alarm
This icon flashes when the alarm has triggered.
Tag Detected
If you are using the LST 1700 with tagger activated or the
optional LT1000 Leakage Tagger, this icon appears when
your CLI-1450 has detected the tag signal. This is an
indication that the source of the leak originates from the plant
you are testing.
2-2