Adjusting The Support Angle - Otto Bock Start M1 Instructions For Use (Qualified Personnel

3) Install the cotter pin in the footrest.
16
Version 2
1) Loosen the set screws on the locking mechanism (see fig. 17).
2) Adjust the lower leg length (continuously adjustable). Ensure that the footplate bar is inserted into the swivel
segment by at least 40 mm.
INFORMATION: A mark on the footrest bar indicates the minimum distance the footrest bar must be
inserted during installation.
3) Tighten the set screws on the locking mechanism to 8 Nm.
17

6.7.2 Adjusting the Support Angle

The footrest angle setting should be chosen so that the ankle is in a relaxed, comfortable position.
"Angle-Adjustable" Footrest
1) Loosen the Allen head screws on the footplate (see fig. 18).
2) Rotate the footplate to the desired angle (see fig. 19).
3) Tighten the Allen head screws to 10 Nm (see fig. 18).
Start M1
Settings
Ottobock | 15