Display; Spo2 Setup - Northern Meditec Taurus E Operator's Manual

文件编号：NR-TP-0715-008
Note

Turn on the monitor, plug in SPO2 probe and connect patient's finger, monitor
displays SPO2 wave， 【SPO2 Pulse Search】 displayed in the technical alarm area
until the monitor measured SPO2 value and pulse rate. 【SPO2 Search Timeout】
displayed in the technical alarm area until the monitor measured pulse rate. Check
the sensor mounting position, whether the sensor is damaged or sensor type.
Reconnect the sensor or use new sensor.
8.4

Display

SpO2 parameter area is shown in Fig. 8-1.
SpO2 wave is shown in Fig. 10-2.
8.5

SpO2 Setup

Select SpO2 parameter area or Pleth wave area → [SpO2 Setup] menu, which is shown
below. You can set SpO2 through [SpO2 Setup] menu.
Fig. 8-1 SpO2 Parameter Area
Fig. 8-2 SpO2 Wave
版本： 1.0
- 42 -