Table of Contents
Advertisement
文件编号：NR-TP-0715-008
If there is carboxyhemoglobin, methemoglobin or dye diluted chemical, the SPO2
value will have deviation.
When the patient has a tendency to hypoxia, use the oximeter to analyze blood
samples in order to fully grasp the patient's condition.
Do not put the sensor on limbs with arterial duct or intravenous tube.
Do not intertwine electrosurgical equipment cable with the sensor cable.
Avoid using the monitor and sensors while using the NMR equipment, in order to
avoid severe burns to the patient as a result of induced currents.
During long time continuous monitoring of a patient, check the position of SpO2
sensor once every 2 hours, and move properly when the skin changes or every four
hours. Some patients may require more frequent inspection, such as patients with
perfusion disorders or sensitive skin, because persistent and prolonged monitoring
may increase unpredictable skin changes, such as allergies, redness, blistering or
pressure necrosis.
Carefully select SpO2 alarm upper limit. High oxygen level will cause crystal-like
fibrous tissue disease to premature children.
Note
Do not put the oxygen probe and blood pressure cuff on the same limb, because
blood flow occlusion during blood pressure measurement will affect the SpO2
readings.
This monitor cannot be used to verify the accuracy of SPO2 Probe and SPO2
machine.
8.3
Monitoring Steps
1.
Select the appropriate SpO2 sensor according to the patient.
2.
Turn on the monitor, and connect the SpO2 lead wire to the monitor.
3.
Clean the measurement site, such as finger with nail polish.
Put the SpO2 sensor probe on the patient's body.
4.
5.
Select the appropriate alarm settings.
6.
Start monitoring.
版本： 1.0
- 41 -
Advertisement
Table of Contents
