IMO Precision Controls K7 Series User Manual page 114

Chapter 7 Usage of Functions
2) Names of parts and functions
Explain about names of parts and functions
⑤
⑥
③
②
⑦
①
④
No
RUN LED
Indicate the operating status the G7F-ADHA
Analog input terminal
Voltage Input
CH0 (INPUT)
V0 I0 COM0
When current input is used, short the V and I terminal.
Jumper pin of analog input
Input
Selec
CHO CH1
Right is CH.1selecting
left is CH. 0 selecting
Analog output terminal
Voltage output
V+ V- I+ I-
OUTPUT
Only one type of output (Current or Voltage)is available on a
module
External power input terminal
Terminal supplies 24VDC
Extension cable
This cable is used to connect while analog mixture module is used..
Extension cable connector
The connector connects extension cable when extended module is
used.
7- ５１
Contents.
Current input
CH0 (INPUT)
V0 I0 COM0
Voltage Current
Input Input
Connect upper
Connect lower parts by
parts by jumper
jumper pins.
pins
Current output
V+ V- I+ I-
OUTPUT