Checking Water Filter; Exterior - Hoshizaki ROX-20TA-U Instruction Manual

5. CHECKING WATER FILTER

* The Water Filter should be installed as shown in the following illustration.
Water Pressure Gauge
(For water supply)
Water Supply
Water Softener
* Measure pressure on the water supply side and unit side. Contact an authorized Hoshizaki
service company for a filter change if the pressure difference is over 15PSIG (0.1MPa).

6. EXTERIOR

Do not splash water directly onto the unit. It may cause a short circuit, electric
shock, corrosion or failure.
Do not use thinner, benzine, alcohol, petroleum, powder soap, polish, alkaline
detergent, acid or pot cleaner. They may damage the painted or plastic surfaces.
1) Wipe off the unit with warm water. If a
neutral detergent is used to wipe off the
unit, wipe off again with warm water.
2) The Display Panel, Salt Water Tank and
Remote Controller are plastic. Do not hit
or scratch with a sharp knife, etc.
Water Pressure Gauge
(For unit)
Water Filter
CAUTION
IMPORTANT
40
Fig. 45
Display Panel
Fig. 46
Remote Controller
Salt Water Tank