Salt Water Tank; Checking Water Softener - Hoshizaki ROX-20TA-U Instruction Manual

3. CLEANING SALT WATER FILTER AND SALT WATER TANK
For cleaning and inspection, turn the power switch off and unplug the unit. There
may be water in parts, which may cause an electric shock or burn.
1) Prepare the Salt Water Tank. Remove the Salt Water Hose and Cap from the Salt Water
Tank when using the Accessory Salt Water Tank.

Salt Water Tank

2) Rinse the Salt Water Filter attached to the Salt Water Hose with warm water and remove
dirt and dust from the Salt Water Filter.
3) Clean the Salt Water Tank with a neutral detergent and remove salt lumps, dust, etc. Rinse
the Salt Water Tank well.
4) Wipe off the Salt Water Tank.
5) Put the Salt Water Hose with the Salt Water Filter through the Cap and push in the Salt
Water Hose until the Stopper hits the Cap. In case of using a larger tank, install the Salt
Water Hose so that the Salt Water Filter on the Salt Water Hose can reach the bottom of
the tank.

4. CHECKING WATER SOFTENER

* Check that water from the Water Softener is soft.
* Check that there is enough salt for regeneration in the Water Softener.
* For other instructions, follow the Instruction Manual for the Water Softener.
CAUTION
Fig. 44
39
Cap
Salt Water Hose
Salt Water Filter