Installation Of Water Softener (Sold Separately) And Water Filter (Sold Separately); [A] Checks Before Installation; [B] Location; [C] Set Up - Hoshizaki ROX-20TA-U Instruction Manual

The maximum allowable voltage variation should not exceed ±10 percent of the
rated voltage. Operation of the unit outside of this range may cause damage to
the unit or reduction of the performance.
* Usually an electrical permit and services of a licensed electrician are required.
5. INSTALLATION OF WATER SOFTENER (SOLD SEPARATELY) AND
WATER FILTER (SOLD SEPARATELY)

[a] CHECKS BEFORE INSTALLATION

1) Unpack and remove shipping carton, tape(s) and other packaging material(s).
2) Check that all the necessary accessories are included.
3) Follow the Instruction Manual for the Water Softener and the Water Filter.

[b] LOCATION

* Install the Water Softener and Water Filter under the same ambient temperature and water
temperature conditions as the water electrolyzer.
* Follow the Instruction Manual for the Water Softener and the Water Filter.

[c] SET UP

1) Install the valves and pipes following the Instruction Manual for the Water Softener and the
Water Filter.
2) Install a water pressure gauge on the pipe of the primary side of the Water Softener and
secondary side of the Water Filter.

[d] ELECTRICAL CONNECTION

1. This softener must have a separate power supply or receptacle of proper
capacity. Branching off the Power Cord, using an extension cord or sharing a
single power supply with other appliances may result in an electric shock, heat
generation or fire.
CAUTION
WARNING
12