Electrical Connection - Hoshizaki ROX-20TA-U Instruction Manual

2. Do not install the unit where exposed to humidity or splashing water. Reduction
in insulation property may cause an electric leak or shock. Locations should be
at least 6" above the floor to avoid splashing water during kitchen cleaning
operations.
3. Install adequate ventilating system. Hydrogen gas or chlorine gas may cause
health problems.
1. To prevent damage to the unit, do not move the unit with the Door open.
2. The unit should not be submerged in water or become wet.
3. Use glass, plastic or stainless steel containers for electrolytic water. Acid water
may corrode metal.
For best operating results:
* The water electrolyzer should not be located next to ovens, grills or other high heat producing
equipment.
* Location should provide a firm and level foundation for the equipment.
* Allow 6" clearance at rear, sides and top for proper performance and ease of maintenance
and/or service.
* Install the unit in a well-ventilated area. Use fans with diameter over 6 inches (standard air
3
flow rate: 270ft /min (450m

4.ELECTRICAL CONNECTION

1. This water electrolyzer must have a separate power supply or receptacle of
proper capacity. Branching off the Power Cord, using an extension cord or
sharing a single power supply with other appliances may result in an electric
shock, heat generation or fire.
2. The water electrolyzer requires a ground that meets the national and local
electrical code requirements. To prevent possible electrical shock to individuals
or extensive damage to equipment, plug the electrolyzer only into a properly
grounded electrical outlet.
CAUTION
3
/h)) if necessary.
WARNING
11