6) Remove two blind bushings from the unit base and attach the cables to the unit base using
the bushings attached to the Float Switch. See Fig. 14.
Note: Use one bushing for 2 cables.
7) Replace the Rear Panel in the original position with screws.
White
Connector
Cable
Bushing
8. INSTALLATION OF OUTLET VALVES (OPTION)
[a] CHECKS BEFORE INSTALLATION
1) Unpack and remove shipping carton, tape(s) and other packaging material(s).
2) Check that all the necessary accessories are included.
[b] LOCATION
1. This outlet valve is not intended for outdoor use. Normal operating ambient
temperature should be within +40°F to 95°F (+5°C to +35°C); Normal operating
water temperature should be within +40°F to 85°F (+5°C to +30°C). Operation
of the outlet valve for extended periods outside of these normal temperature
Black
Connector
Fig. 12
Fig. 14
Terminal Block
Base
WARNING
20
Fig. 13