[C] Set Up - Hoshizaki ROX-20TA-U Instruction Manual

ranges may affect performance.
2. Install an adequate ventilating system. Hydrogen gas or chlorine gas may cause
health problems.
1. Avoid a site where dripping is not allowed. Condensation may form on the
exterior in high humidity and could drip onto the floor.
2. Use glass, plastic or stainless steel containers for electrolytic water. Acid water
may corrode metal.
For best operating results:
* The Outlet Valves should not be located next to ovens, grills or other high heat producing
equipment.
* Location should provide a firm and level foundation for the equipment.
* Install the unit in a well-ventilated area. Use fans with diameter over 6 inches (standard air
3
flow rate: 270ft /min (450m

[c] SET UP

Use the PVC pipes for electrolytic water piping. Other materials may cause
corrosion and water leakage.
1) Choose a dispense method (Water Pump or Water Tank) depending on the installation
situation. Install PVC pipes from the Water Tank to the location where electrolytic water is
used.
Note: In case of using a Water Pump, follow the instruction manual for electric wiring and
piping.
2) Connect the Valve with the Flexible Pipe.
Note: Before fitting the Flexible Pipes into the Valves, wrap the pipe threads with sealing
tapes.
Do not misconnect the Accessory Flexible Pipes: Yellow pipe - Acid water
The Valves are common to both acid and alkaline water.
CAUTION
3
/h)) if necessary.
CAUTION
21
Blue pipe - Alkaline water