Hoshizaki ROX-20TA-U Instruction Manual page 20

Bracket. The space between bracket holes is 7" and there are two 8mm holes.
5) Attach the Electrolytic Water Pipes to the Remote Controller after the Remote Controller is
installed on the wall. Make sure that there are Gaskets on the end of the Pipes.
Remote Controller
Acid Water Hose
Note: The vertical height of the hoses for electrolytic water should be a maximum of 80" and
the total piping length should be within the range that the PVC Braided Hose can
reach. The electrolytic water may not be able to flow or the flow rate may not be
maintained if the total piping length is outside this range. Adjust the pipe length using
the PVC Braided Hose to maintain the proper performance of the electrolytic water.
Install the Remote Controller so that the outlets are located above the unit. The difference
in the gas amount between acid water and alkaline water may change the flow rate
balance and cause poor performance.
Install the Remote
Controller so that the
outlets are located
above the unit.
6) Attach the caution label (Accessory) in readily visible position near the Remote Controller.
Tapping Screw
Bracket
Remote Controller
Fig. 4
Gasket
Alkaline
Water Hose
Gasket
Water Electrolyzer
Fig. 6
Fig. 7
16
PVC Braided Hose
Clamp
Connector
Fig. 5
Alkaline
Water Hose
Acid Water
Hose
The vertical height and
total piping length should
be within the range that
the PVC Braided Hose
can reach.