Polycom RMX 1500 Quick Installation And Configuration Manual page 17

Flag
Terminate Conference
when Chairperson Exits
Auto Extend
Conferences
These flags can be modified later, if required. For more
information, see the RMX 1500/2000/4000 Administrator's Guide,
"System Configuration Flags".
37 Click Save & Close.
The RMX confirms successful configuration.
38 In the Success Message box, click OK.
39 In the Reset Confirmation dialog box, click Yes.
40 In the Please wait for system reset message box, click OK.
System restart may take up to 10 minutes.
41 Refresh the browser periodically until the Login screen is displayed.
42 When the Login screen is displayed, enter the new Username and
Password and click Login.
The RMX Web Client opens.
An MCU State indicator displays a progress indicator showing the
time remaining until the system start-up is complete.
When the default RMX User is replaced and the RMX Time is set
and if there are no System Errors, the green READY LED on the
RMX's front panel turns ON and the red ERROR LED turns OFF.
The Fast Configuration Wizard configures the Default IP Network
Service with common parameters. The speed and transmit/receive
mode of each LAN port used by the system are automatically
identified by the system but can be manually modified if the specific
switch requires it in the Ethernet Settings dialog box. Specific or
additional settings (e.g. for ICE, or Secured Mode) should be
performed once the initial configuration is complete. For more
detailed, see the RMX 1500/2000/4000 Administrator's Guide.
Value
Yes/No (Default: Yes)
When Yes is selected (default) allows conferences
running on the RMX to be automatically extended
as long as there are participants connected and
there are available resources.
17