Unpacking The Rmx - Polycom RMX 1500 Quick Installation And Configuration Manual

If ISDN/PSTN is installed in your conferencing environment, obtain the
following information from your ISDN/PSTN Service Provider:
• Switch Type, Line Coding and Framing, Numbering Plan and
Numbering Type
• Dial-in number range
If the RMX is connected to the public ISDN Network, an external
CSU or similar equipment is needed.
1
When you receive the RMX 1500 packing case, inspect the
equipment for damage and verify that the components match the
packing slip.
2
Open the top cover of the RMX 1500 packing case and make sure
that the Installation Accessories kit contains the power cables and a
USB Key and that Rack Installation Accessories kit contains the
accessories for installing the RMX in 19" racks. For details, see the
RMX 1500/2000/4000 Getting Started Guide, "Telescopic Rail
Runners Accessory Kit" on page 2-9.
3
Remove the top cover, lift the RMX 1500 from the package and
place it on a flat surface.
Write down the RMX's serial number that is on a sticker on the back
of the unit. It will be needed for product registration later in the
installation process.
Management Network Configuration on the
The system is shipped with the following default IP addresses:
• Control unit IP address – 192.168.1.254
• Shelf Management IP Address – 192.168.1.252
• Control unit subnet mask – 255.255.255.0
• Default Router IP Address – 192.168.1.1
2

Unpacking the RMX

USB Key