6.3.
VIDEO CONTROL
The Video Control tab is used to force a video standard and read back the currently detected video
standard on the input.
6.3.1. Viewing the Detected Video Standard
The Detected Video Standard field displays the currently detected input video standard.
6.4.
AUDIO CONTROL (+UMX, +IG AND +DMX ONLY)
The Audio Control tab is used to set the C-bit state in the output video's embedded audio.
6.4.1. C-bit Control
The C-bit Control drop down menu provides the following two options:
•
Preserve, which will pass through the state of the bit.
•
Replace, which will set the state of the bit to Active.
7800IDA8-3G 3G/HD/SD-SDI Intelligent Distribution Amplifier (1x8)
Figure 6-2: Video Control Tab
Figure 6-3: Audio Control Tab
Revision 1.2
7700/7800 MultiFrame Manual
Page - 11