Table of Contents
Advertisement
1.4.1. Activating the front camera input (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the front camera power supply: see chapter "Power supply output".
1.4.2. Enabling the interface's video inputs (dip 2-3)
Only by dip switches enabled video inputs can be accessed by switching through the
interface's video sources. It is recommended to enable only the required inputs. Disabled
inputs will be skipped while switching through the video interfaces inputs.
1.4.3. Activating the PDC function (dip 4)
When set to ON, the PDC car is displayed on the monitor and the distances are displayed,
based on the CAN data received.
Note: If the interface does not receive data from the vehicle CAN bus (some vehicles are not
compatible), the parking distance cannot be displayed. In this case, set dip4 to Off.
1.4.4. Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.5. Activating the guidelines (dip 6)
If set to ON, the interface is activated to show the guide lines for the rear-view camera while
the vehicle is in reverse mode (not available for all vehicles).
Note: Some vehicles have a different code on the CAN-bus which the video-interface is not
compatible with. If the interface does not completely communicate with the vehicle CAN
bus, the reverse gear guide-lines can`t be shown during the vehicle's operation, even if they
in some vehicles once appear after having switched the system to powerless!
1.4.6. Monitor selection (dip 7 and 8)
Dip7 and 8 change the monitor-specific video settings.
Try all possible combinations of Dips 7 and 8 to receive the best picture (quality and size)
After each Dip-switch-change a power-reset of the Can-box has to be performed!
Version 08.07.2022
HW:CAM(V100)/(V30.3)
RL4-MGU
Advertisement
Table of Contents
