Table of Contents
Advertisement
1.4.1.1.
Activating the front camera input (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the front camera power supply: see chapter "Power supply output".
1.4.1.2.
Enabling the interface's video inputs (dip 2 and 3)
Only the enabled video inputs can be accessed when switching through the interface's video
sources. It is recommended to enable only the required inputs, disabled inputs
will be skipped when switching through the video-interfaces inputs.
1.4.1.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera.
If set to ON, the interface switches to its rear-view camera input
reverse gear is engaged.
1.4.1.4.
Art der Frontkamera-Aktivierung (Dip 6)
If the dip switch is set to ON (and dip1 is set to ON), the interface switches from the rear
camera to the front camera input for 10 seconds after reverse gear is disengaged. In
addition, manual switching to the front camera input is also possible from any image mode
by pressing the button (short press).
With the dip switch set to OFF (and dip1 set to ON), automatic switch-back tot he front
camera is deactivated, but the manual front camera switching option via external keypad
remains.
1.4.1.5.
Monitor adjustment (dip 7 and 8)
Dip 7 and 8 are for monitor-specific video settings which cannot be predicted as even within
the same head-unit version, the monitor specifications may vary. It is necessary to try all
possible combinations (both OFF, both ON, 7 OFF and 8 ON, 7 ON and 8 OFF) - while a
working video source is connected to the chosen input of the interface - to see which
combination gives the best picture quality and size (some may give no picture). It is possible
to first hot plug through the dip combinations, but if you do not experience any change of
picture after trying all 4 options, retry and disconnected the 6pin power plug of the video-
box between every change of the dip setting.
Note: Dip 4 is out of function and has to be set to OFF.
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
Version 23.11.2022
CAM(V100)/ (EF2L145/V20)
„V4 Reverse"
while the
RL4-NG4-HU
Advertisement
Table of Contents
